EJ series / Greenhouse Accessories, greenhouse spring, greenhouse lock channel

To build a greenhouse with DEAR DEER EJ series accessories

  1. 1. Stand the framework of greenhouse (0.5 to 1 meter distance each arc) as your need. To prevent very strong wind it is recommended 0.5 meter distance each arc and the ends of stand pillar must be buried underground 45 to 60 cm. In case of the wind is not so strong it is enough to distance 1 meter each arc.
  3. 2. Put pipes across to stand pillars and connect them with EJ-101 “Hoop And Purlin Spring Cross Connectors”.

   

  1. 3. Put EJ-103 “Film Lock Channel” across to stand pillars and screw it on the pillars to fix them together.
  3. 4. Cover and tighten plastic film on the framework of greenhouse.
  5. 5. Tighten and set cover film into “Film Lock Channel” with EJ-102 “S spring wire”.
  7. 6. In case of the “Film Lock Channel” is not long as your need connect 2 “Film Lock Channels” with EJ-104 “Film Lock Channel Connector” to lengthen.

  

  1. 7. Tighten EJ-108 “Tension Band” on the roof of greenhouse to make film firmly. Then tie the “Tension Band” on EJ-105 “Band Set Hook” in “Film Lock Channel”.
  3. 8. To snap film on pipes with EJ-106 “U Snap Clamp” at where “Film Lock Channel” can’t be used. For example we can snap film at roof arc.

 

  1. 9. Install EJ-107 “Film Roll Winder” with 2 stand pipes as 2 guides at 2 ends out of greenhouse and a pipe across with film roll in. In general we stand film roll winder sets at 2 sides, or add1 or 2 sets at front and rear to roll up for ventilation.
  3. 10. Set insects net inside the film on the wall where the film roll up, to prevent insect invasion.